plane section
英 [pleɪn ˈsekʃn]
美 [pleɪn ˈsekʃn]
网络 水平断面
英英释义
noun
- (geometry) the area created by a plane cutting through a solid
双语例句
- Ore plane, section and grade models have been set up based on MAPGIS software.
用MAPGIS建立起矿床的平面、剖面和矿石品位的模型。 - The superposition theory has the lower bound theorem of the plastic theory as its foundation. The simplified formula of the superposition theory is easy to use and its result is quite close to the accurate solution of the plane section method.
结果表明，叠加方法不仅以塑性理论下限解为理论基础，且所得到的简化计算公式简便适用，与平截面法和规范方法计算结果的误差在工程可接受的范围内。 - The faults control the distribution of orebodys from plane and section. 4.
断裂从平面和剖面上都控制了矿体的分布。 - The test results indicate that the ultimate load bearing capacity and the behavior of deformation of the timber beams is greatly enhanced after strengthened by CFRP, and the longitudinal strains of intact beams and strengthened beams are all consistent with the assumption of plane section.
试验结果表明，采取碳纤维布加固木梁，其承载力得到大幅度的提高，变形性能得到显著的改善，加固前后截面应变均符合平截面假定。 - The strain measurement proves that the average strains agree with the assumption of plane section.
应变量测表明平均座变符合平截面假定，少数试件且量测至破坏阶段。 - A method to calculate the section curvature ductility index of high strength concrete shear wall is induced by using stress-strain relationship of rectangle stirrup and plane section assumption.
利用矩形箍筋约束混凝土的应力一应变关系和平截面假定，建立了高强混凝土剪力墙截面曲率延性系数的计算方法。 - However, the theoretical analysis, only considering regular structure, is based on some hypothesis, such as isotropy, small deformation and plane section assumption. The numerical simulation of non-continuum is also difficult.
但理论分析基于各向同性、小变形和平截面等假设，仅考虑比较规则的结构形式，而数值模拟对非连续体的精确计算又十分困难，必须借助实验验证的手段进行研究。 - The applicability of the formula of the longitudinal shear force flow of the plane beam to calculate the studs 'loading forces of composite beams, which is based on the plane section assumption in mechanics of materials, are reviewed and evaluated.
考察评价了材料力学中基于平截面假定的计算平面梁纵向剪力流公式计算组合梁栓钉受力的适用性； - Based on the plane and section isoline of fluid potential, the distribution features of liquid flow in the studied areas were analyzed.
在编制流体势平面和剖面等值线图的基础上，分析研究区的流体势分布特征。 - Based on the plane section assumption and the formulas of compression members with small eccentricity, the interaction diagram of ξ-m, n and the linear interpolation formula of ξ according to the calculation of rectangular section capacity with asymmetrical reinforcement are presented.
根据平截面假定和小偏心受压构件的基本公式，通过对矩形截面非对称配筋承载力的分析计算，给出了ξ与m，n的关系以及计算ξ的线性内插公式。